SIGNALBOOST amplifier, iDen Band 806-824 MHz/ 851-866 MHz iDen network, Bi-Directional 3 Watt Amplifier/ Booster, Wilson model 804002: all iDen Band 806-824 MHz/ 851-866 MHz iDen networks used in the Americas 12 volt DC cigarette lighter plug and Slim low profile inside antenna included (301127) with this BDA for iDen networks
SIGNALBOOST amplifier, iDen Band 806-824 MHz/ 851-866 MHz iDen network Amplifier/ Booster, Wilson model 804002.
Wilson's Bi-directional 3 watt Amplifier: improves RF coverage in areas with low signal strength. The RF signal is received by the optional outside antenna from the cell site. The RF signal is then AMPLIFIED and transmitted into your iDen phone through the included Slim low profile inside antenna (301127), or an optional RF adapter/ cradle. When the iDen phone transmits, the signal is sent to the amplifier through the optional RF adapter/ cradle, or Slim low profile inside antenna included (301127), then AMPLIFIED and sent to the cell site through the optional outside antenna. Simply place your cell phone into the RF inductance cradle, or locate your cell phones close to the Slim low profile inside antenna included. The cradle has a 6 foot RF cable to connect into the amplifier. An RF inductance cradle # 301146 with FME female connector to mate to this iDen RF amplifier is PREFERRED.
Wilson Electronics SIGNALBOOST 800 MHz iDEN Band amplifier/ booster has 10 times more power than your cell phone or laptop data card alone. This iDen band amplifier improves voice and data signal. This amplifier also reduces battery use on the cell phone.
12 volt DC Cigarette Lighter Plug is included for easy self installation. A 12 volt power supply of at least 2 Amps is required for indoor applications.
3 watts maximum output: Power control logic ensures maximum output power is within iDen network standards, since Gain is network controlled.
Wilson Model 804002 works on all iDen Band 806-824 MHz/ 851-866 MHz iDen networks used in the Americas.
Note: Not compatible with normal Cellular or PCS cell phone on other networks.
Works great indoors, in-building and marine applications.
Specifications: Max RF +35 dBm / +10 dBm. Noise Figure 4 dB nominal. Flatness 3 dB / 3 dB. Isolation (uplink/downlink) >90 dB. Power Requirements 12 Volts DC, 1.5 Amp minimum. Connectors on Amplifier are FME-Male and 50 ohms. Dimensions 5.5 x 4.3 x 1.4 inches/ (14.0 x 10.8 x 3.5 cm). Weight 1.32 pounds / 0.6 kilograms. Model Number 804002 operates at iDen radio frequency bands of 806-821 MHz Uplink 851-866 MHz Downlink.
No adapter is needed to use with Wilson 301146 RF inductance cradle or Wilson Tri-band antenna 301101.
FCC and IC type accepted. US and foreign Patents Pending.
Wilson Electronics factory original One year warranty applies.